The QuarkX Energy Revolution – A 100W Eternal Matchstick with COP~200 Heat and COP~20 Electricity!

The QuarkX Energy Revolution – an Eternal Matchstick!

The 100W matchstick … with a COP~20 Electricy and a COP~200 heat …

 

— from ECAT.COM

quark

Report Disclaimer:

THIS IS NOT A THIRD PARTY REPORT AND ALL THE MEASUREMENTS HAVE BEEN MADE BY ANDREA ROSSI AND HIS TEAM. THEREFORE THESE RESULTS CANNOT BE CONSIDERED AT ANY EFFECT OTHER THAN AN INTERNAL PROCESS CONTROL, NOTHING MORE.

DESCRIPTION OF THE QUARK X:

Cylinder made with proper material:

  • Dimensions:
    • length 30 mm
    • diam  1 mm
  • Energy produced: 100 Wh/h
  • Energy consumed: 0.5 Wh/h
  • Light produced (percentage of the energy produced): 0-50%
  • Electric energy produced: 0-10%
  • Heat produced: 0- 100%

Light, energy and heat can be modulated to modulate the percentages within the limits above listed, provided the combined percentages must total 100%.

Extremely interesting is the blue light, the analysis of which has resolved theoretical problems related to the roots of the effect.

Temperature on the surface of the QuarkX: more than 1,500*C
Note: 2 other QuarkX put in analogous situation gave the same results.

Further disclaimer:

THIS IS NOT A THIRD PARTY REPORT. IT IS AN INTERNAL REPORT RELATED TO MEASURES MADE BY LEONARDO CORPORATION

End of the report.

Description of the photo:

Photo of the heat exchanger pipe that contains the QuarkX: the light spot is through a light eye holed in the pipe. The blue halo from the hole has been analyzed and has made possible to understand the theoretical roots of the effect: the QuarkX is inside the pipe .

NOTE: THE PHOTO HAS BEEN MANIPULATED TO FORBID HIGH DEFINITION. The colors have been partially obscured. The light is much more intense.

5 thoughts on “The QuarkX Energy Revolution – A 100W Eternal Matchstick with COP~200 Heat and COP~20 Electricity!

  1. Nickel is melting at 1455 degrees. How can it be more than 1500 ?

  2. ECAT NEWS dying

    begin citation
    ============
    The End

    EcatNews has outlived its purpose. Anyone determined to invest in this technology based on Andrea Rossi’s word or on reports generated by anything other than an independent and credible organisation, is beyond help. I will leave this site up for research purposes but will eventually let it…
    ========
    end citation.

    Now, were all the anti-rossi trolls (hosted there) will go next ?

    • As Paul Story (owner of ECN) is hinting, it will take months of purification to clean the dungeon out – few normal people can tolerate the stench there let alone interact with the dwellers within, for any length of time 🙂

      (just could not resist this parting remark and yes it is unkind – I admit it!)

      Doug Marker

  3. June 17, 2016
    Ophelia,

    It is a very difficult position to say you did not pay the man the tens of millions you owe him because the product does not work, and at the same time sue the man for control of the territory where he is manufacturing working product.

    IH has made it’s decision. They bought rights to a different product which they say does not work, even if they maintained the rights from the initial payment, Rossi will be manufacturing a different product.

    I expect that any rational judge would club IH like a baby seal if they contest the territory after having abandon the payment obligation on a technicality.

    It really looks like IH was only trying to kill off Rossi as potential competition for some other client.

    I sincerely doubt there will be any lingering legalities.

    You are either on the bus or off the bus. IH is officially off the bus.

Comments are closed.